Think of the Regius as a narrower but slightly longer version of the Granvia. (Now, does that give you a clue as to how to answer the question?)
I must be getting old as I still have not a clue as to the answer to the question on the Regius forum register.
That aside I have nearly finished my camper conversion. went fine but more to it than at first thought. The little things take up so much time/ the electric curtains, the seat runner remove or stay, design thinking of getting the best of a small space eats up the day.
My current question is on split charge relay, having fit a TEC3M voltage sensing relay with led voltage display to both batteries that show 12.5v about to both with the engine stopped and 13.5 - 14.2v to the starter bat. and 12.5v to the leisure bat. with the engine on. The starter bat. is charging but not the leisure. As I have done only short drives since fitting the Tec3m relay I wonder if its voltage sensing is giving priority to the starter bat. and it will eventually charge the other when the first is fully charged. Question does the TEC3m work that way, or is it a fault in relay or circuit ?
Is there any way to check the Tec3m?
As for charging chassis batteries and House one, what I did in my motorhome was just connecting the two banks with a 12ga. wire, a 20 amp fuse and a few banana clips.
Once I parked the unit, disconnected the wire. Maybe a bit more work, but its simple.
excellent of them as ebay suppliers.
But Im still having a problem as the 29 amp fuse blows on start up. How can this happen? the starter drawing current from the leisure bat. but I thought the relay isolated it??? look like iv done in this relay////I could do as above or use a switch but it become a challange.
does any body know where the alternator light feed could be tapped to supply a traditional split relay?
Or is this not an option with these engines?
Who is online
Users browsing this forum: No registered users and 2 guests