Whats a good size of wider wheel to fit to fill the arches really well and without clearance issues.
for road use only but for work so not low profile tyres.
Ill look forward to reading any advice.
60 profiles are a good compromise of better handling but still give a reasonable ride.
I think it's possible to go for 17 or even 18 inch, but you would then be into ultra low profiles or risking fouling problems
Hope this helps
I think they are 7J width (might be 6.5) with a moderately negative offset, but I will have a proper measure at the weekend
Look like 8" wide - offset backspace (inner) measures approx 140mm from inner rim to mounting flange face. Have never had any fouling problems so confident these dimensions are safe
Hope this helps
Was considering larger diam. wheels, not so much for looks, but more as an overdrive, as the 3 ltr appears to have enough surplus power
and am not using it to pull trailers.
The MPG appears to be a sensitive point on these cars and reducing say your revs by 10% should make a difference,
trying to stay around the max torque of 2000rpm.
Better watch my odometer.
My 1997 Granvia 4WD (only travelled 69,000 kms!) is geared so that 2100 rpm maximum torque corresponds to ~90kph.
This means at 100 kph highway speeds the engine is doing close to 2600 rpm which impacts pretty heavily on diesel consumption.
Looking at some generic wheel/tyre sizing and doing some calculations I come up with the following (sorry but I'm an engineer):
Tyre Size revs/km speed factor Speed at 2100 rpm (kph)
215/70 R15 (stock) 467 - 90
215/75 R15 452 1.03212 92.9
215/80 R15 439 1.05996 95.4
215/70 R16 450 1.03640 93.3
215/75 R16 437 1.06424 98.9
Firstly are the higher profile tyre options all going to fit (i.e. not rub) with the stock +29mm offset?
Are there likely to be any significant handling/stability issues with 15" or 16" and higher than stock 75 or 80 profile tyres?
My leaning is towards the 215/80 R15 tyres so I'm gaining 5.4 kph @ 2100rpm but don't have to change out the very good condition existing 15" steel rims. Has anybody installed 215/80 R15 tyres on their 4WD Granvia? Will they fit? I know the 215/75 R15 tyres fit as a friend with a Regius has these.
I'm concerned that the higher 80 profile tyres lifting the entire van 20.5mm (0.81") may result in poor cornering as these are already a big heavy van.
Thanks for any help or thoughts
Normal driving they work well. As for the higher center of gravity, not much affected adversly, but then the van width is rather narrow compared to its height and one can feel the difference with the lower suv.
It does bring down the rpm, but can´t remember the details. I do think I commented on this in an earlier comment. I think it was about 4-5%.
The van has more than enough power to handle it, but obviously going uphill it looses power and I do down shift before the automatic does.
Did the same on the 2000 Granvia Cruising Selection AWD 3.4ltr gasoline, again the snowtires rub against the slashguard when parking, so removed those. Had no problems with the all season tires of same size.
The diesel gets a little better mpg or 8-9km/ltr at around100-110km/hr, between sealevel and 4500ft, while the gasoline van uses somewhat more,
which is quite a bit for a small van. Our Dodge 4x4, 3/4 ton p/u truck with a 5.9ltr Cummins, net weight 3100kg gets about the same mpg.
Who is online
Users browsing this forum: No registered users and 4 guests