Im from the UK but have been living in New Zealand for the last 2 yrs where grannys are very popular...
So I bought an mx bike and with Toyota being the car of choice here, parts and mechanics readily available, the granvia looked like the perfect mx van to convert.
Problem is they only come in 7 or 8 seaters I believe so to get an mx bike in modifications had to be made, but was easily done.
I removed the rear bench of 3 and single swivel seat and did some simple modifications to the double seat in the back. The double seat can now rotate anti-clockwise so you can sit facing the sliding door, backward and forward and be pushed right up hard against the driver’s seat so a double air mattress can fit behind it. I removed redundant rails and re-floored the van with carpeted 20mm ply and 10mm polystyrene to absorb and vibration and build the floor up to the trim as the old floor was 30mm thick.
Also note the method I have for fastening the bike in. I thought it up in bed one night, tried it the next morning on a trailer and its awesome, so simple and quick saves you having untidy straps everywhere and the bike is solid, no movement at all and doesn’t pull down on the suspension half as much as straps
This will work just as well for track bikes and iv even picked up the missus broken down scooter a couple of times.
So as you can see I now have a 3.0TD granvia that will legally seat 4 people, carry a full size mx bike and if need be you can sleep in the back. (rear double seat can aslo face forward with bike in, not shown in pix)
- 19 - Copy.JPG (81.58 KiB) Viewed 6891 times
- 18 - Copy.JPG (117.11 KiB) Viewed 6891 times
- 17.JPG (102.58 KiB) Viewed 6891 times
Basically unbolt the seat from the sliders and remove both back rest and seat cusions so your down to the bare frame.
I cant remember the exact method but you will see the rotating mechanism is round with about 8 bolts around its circumferance. You need to fully disassemble this (it gets greasy). Once all the bolts are out tho be carefull not to pull it apart too quick, either mark which holes lined up or remember as you need to lift the top ring off, rotate it 180degrees and put back down to line up with the opposite hole then re-assemble...
Thats the basic concept, like i say i cant remember exactly but it becomes pretty self explanitory as you get into it.
Once it is done there is 2 slight issues tho..
There isnt actually a position for it to 'click' into at 90 degrees, you will havto fabricate this and weld it to the ring, just replicate what you see at the other 2 positions (really simple although i havnt done it, when its in that position it can still swivel a bit but doesnt bother me, if i had a welder i would do it).
Also, when you go to rotate it to face either back for forward the back corners of the seat plastic will rub on the side of the interior trim, not a whole lot but in the long term after a couple hundred turns or so you will have a rub mark on the inside wall of the van down low.
These 2 issues are worth it to be able to have the seat this way i reckon.
Cheap easy job
Was your Grannie a 7 or 8 seater? You mention a double seat and a single swivel.
When the seat is across the width of the van, is it anchored at both ends, or is it restrained by the locked swivel mechanism?
yeah the bench of 2 in the middle was already a swivel seat and when locked in across ways its just locked in by a mechanism on the swivel rings underneath, not either end of the seat.
Who is online
Users browsing this forum: No registered users and 2 guests